Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Nozzle Installation
1.
Remove the battery from the unit.Next fi ll the tank by fi rst removing it from the unit by rotating the tank locking
collar and pulling the tank release ring. The tank can now be removed.
Note: you must hold on to the tank when you pull the tank release ring or the tank will fall to the fl oor.
2.
Insert the nozzle wrench into the front end of the unit.
3.
Rotate wrench until the tabs on the nozzle and the slots on the wrench are lined up.
4.
When the wrench slots and the nozzle tabs are lined up, the wrench will be completely inserted into the front end,
rotate the wrench clockwise to adjust to a diff erent size spray. The largest particle tip has a line cut through it, rotate
clockwise until you hear a click to get the medium particle and rotate clockwise again until it clicks again to get the
smallest particle.
5.
Remove the wrench when complete.
To Insert Nozzle
1.
Remove the battery from the unit.
2.
Insert the nozzle into the wrench, lining up the tabs on the nozzle and the slots on the wrench.
3.
Insert the wrench with nozzle into the front end of the unit.
4.
Push in and rotate the wrench ¼ turn counter clockwise. When you hear a click the nozzle is in position..
5.
Remove the wrench when complete.
Removing The Nozzle
1.
Remove the battery from the unit.
2.
Insert the nozzle wrench into the front of the unit.
3.
Rotate wrench until the tabs on the nozzle line up with the slots in the wrench.
4.
When the tabs and slots are lined up the wrench will be completely inserted into the front end.
5.
To remove, rotate the wrench in the counter clockwise direction until the nozzle comes loose (1/4 rotation).
6.
Remove the wrench when complete.
Cleaning Procedure
All users follow safe cleaning practices to protect themselves from harmful exposure when cleaning the sprayer.
It is recommended that user should purchase a second tank to wash out cordless electricstatic sprayers to prevent residual
solution build up. Disconnect storage tank from sprayer use the black threaded cap that's is provided inside caring case.
Disconnect storage tank from sprayer use the locking threaded cap to secure tank and solution when not in use.
1.
Turn sprayer switch off .
2.
Remove battery from compartment.
3.
Remove tank from base.
4.
Add clean water to tank by removing tank cap.
5.
Re-install tank into base.
6.
Turn power ON.
7.
Spray (1 minute) per each nozzle setting until free of containments.
NOTE: 3-in-1 nozzle has three diff erent nozzle selections (100 Micron) (80 Micron) (40 Micron).
8.
Rotate nozzle three times for (1 minute) until clear water is present.
9.
Disconnect storage tank from sprayer when not in use. Use the black threaded cap. Use the locking threaded cap
(provided inside caring case) to secure tank and solution.
Parts & Operations Manual
Victory Series
7
Publicité
Table des Matières
