VS StepByStep-I 02901 Mode D'emploi page 4

1. Adjusting the table height
(for StepByStep)
The height can be adjusted in steps: 53; 59; 64; 71; 76; 82 cm,
size 2 to 7. There are three basic height settings, each of which
has three fine adjustments.
- Depending on the model, loosen the locking screw
(Allen key, size SW 5) or hand wheel (1).
- Release the table skid from the catch and adjust to the
top or bottom position (see scale).
- Insert the table skid into the catch again.
- Secure using the locking screw or hand wheel (1).
2. Basic height adjustment
(for StepByStep)
- Screw out the locking screw or hand wheel (1).
Caution! -- Child safety mechanism --
1. Screw the hand wheel out of the thread (turns
without engaging),
2. Turn the hand wheel towards you until the second
threaded section engages
3. Screw out completely.
- Position the table skid vertically at the required height
(see scale).
- Secure using the locking screw or hand wheel (1).
3. Adjusting the table top, only for
models 02941, 02942, 02997, 02998
- Angle of inclination adjustable in steps:
4 0°; 5°; 10°; 16°; 20°.
(1)
-
-
-
4. With rollers (optional)
The table top must be empty before the table is moved. Only
empty tables may be wheeled in this way. To prevent damage
to the rollers, do not wheel the tables over door sills or uneven
surfaces.
Slightly lift by users.
Press the release lever (2) (on the pupil's side on the
right and left below the table top) upwards (towards
the table top) and hold it in place.
Move the table top sideways and adjust it to the re-
quired angle of inclination.
It engages at the different available levels of adjustment.
Caution! Only lift the table slightly as there is other-
wise a danger it may tip over.
(2)