Barrette Bella Premier Serie Instructions D'installation page 7

6.
Install 3" support brace to rail:
3" support braces are included with railing kits.
Two support braces are included with 8' and 10'
railing kits. Install support braces evenly across
span of railing section.
Locate and mark the center point on the
underside of the bottom rail. Attach the rail
support to the bottom rail using the supplied set
screw (Fig. 8).
7.
Assemble Railing Section:
Lay bottom rail on a clean smooth surface and
snap balusters into routed holes (Fig. 9). Then
repeat the process to connect the top rail (Fig. 10).
8.
Slide brackets onto ends of rails (top and bottom)
(Fig. 11).
9.
Place Assembled Rail Section over Angled
Bracket Bases:
Slide assembled rail section straight between both
posts, and over each angled bracket base (Fig. 12).
Slide provided pins in top/bottom angled brackets
to lock angled brackets to base.
NOTE:
When installing angled rail and connecting the
rail section, the angled bracket base needs
to be ipped on the opposite post based on
direction of the install.
10.
Install two 1
angled bracket, securing it to the handrail. Insert
screw caps onto each top bracket.
⁄ ⁄ " screws into the sides of each top ⁄ ⁄
1 1 1
4 4
Fig. 8
3" Support Brace
Fig. 9
Fig. 10
Fig. 11
Fig. 12
7