Filling The Magazine; Eu Declaration Of Conformity - BEA 380/16-400SP Notice D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
Device-specific additional instructions for nailer
4

Filling the magazine

Ensure that nailer and fasteners are compatible (Chap. 1) with
each other.
Check fasteners for proper condition.
Turn the tool upside down, press the lock 1 and pull the
lower slide 2 backwards. Release the locking button 1,
insert the clamps 3 into the magazine. Then push the lower
slide forward again.
5
Adjusting the degree of flare of staples
To flare the staples more loosen headless screw 1 and tighten
screw 2. Tighten headless screw 1 afterwards. To flare the
staples less, loosen screw 2 and tighten headless screw 1.
Tighten screw 2 afterwards. Check whether clinch plate 4 is
still moving slightly after the adjustment. If necessary, loosen
headless screws 3. With the headless screws 3 the clinch
plate 4 can be centered so that both legs of the staple are
flared consistently.
6
Removing stuck fasteners from the driving channel
Disconnect the tool from the compressed air supply. Open the magazine as described in chapter 4 and
remove the staples. Then reconnect the tool to the compressed air supply and refill it with staples
7

EU Declaration of conformity

The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's
conformity with all relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
Dr. Jörg Dalhöfer, CEO
380/16-400SP
-----------------------------------------------------------
Joachim Bauer, Documentation responsible
EN - 7

Publicité

Table des Matières
loading

Produits Connexes pour BEA 380/16-400SP

Table des Matières