Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- Insert the small plug from the supplied
AC adapter to the DC IN Jack on
the unit.
- Insert the AC adaptor to wall outlet
having AC 100-240V~ AC, 50/60 Hz.
To replace the button cell:
1. Push the tab, then slide out the battery tray as the figure
on the right.
2. Replace the old button cell by a new CR 2025
button cell as the polarity markings on the remote control.
3. Close the battery tray.
BATTERY PRECAUTIONS:
Follow the size and type of battery specified.
1. Use only the size and type of battery specified.
2. Be sure the follow the correct polarity when installing the battery as indicated in the battery
compartment. A reversed battery may cause damage to the device.
3. If the battery in the device is consumed or the device is not to be used for a long period of time,
remove the batteries to prevent damage or injury from possible battery leakage.
4. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.
5. The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
6. Clean the battery contacts and also those of the device prior the battery installation.
7. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zine) or old batteries with
fresh ones.
NOTES:
1. When there is an obstacle between the unit and the
transmitter, the transmitter may not operate.
2. When direct sunlight, an incandescent lamp, fluorescent
lamp or any other strong light shines on the REMOTE SENSOR
of the unit, the remote operation may be unstable.
All manuals and user guides at all-guides.com
5
AC/DC adapter
OPEN
PUSH
Publicité
Table des Matières
