Seatbelt; Using The Wheelchair; General Functions - Bischoff & Bischoff Triplex Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TRIPLEX
| Electric Wheelchair
Distance from the arm support
• You can adjust the position of the control unit to your forearm
length.
• Loosen the hand screw on the outer side of the side part.
• Move the control unit into the desired position, then tighten the
screw again (fig. 14).
14

3.5.8. Seatbelt

The seatbelt is attached to the side of the back support.
• Adjust the length of the seatbelt by positioning the buckle accor-
dingly (fig. 15).
• Fasten the seatbelt with the latch.
• Open the seatbelt by pushing the red button at the latch.
15

4. Using the wheelchair

After adjusting the wheelchair to your personal needs, familiarize
yourself with the control functions.

4.1. General functions

Light
Use this button to switch on the active lighting system of your
wheelchair when darkness falls or when travelling through
dark areas such as tunnels. This will make you more visible to
other traffic (fig. 16).
16
50
Don't forget that the cables to the control unit
have to be repositioned. This should be done by an
expert.
Electric Wheelchair |
Warning lights
Press this button to switch on the warning indicators in emergency
situations, such as inability to move the wheelchair. All four indicator
lights will flash and signal other traffic that your wheelchair is disabled
(fig. 17). For safety reasons, the warning lights will stay activated even
when the control unit is turned off. Turn the control unit back on to
turn off the warning lights by pressing the button.
Indicators (left/right)
Use this button (fig. 18) to switch on the left or right indicators of
your wheelchair to signal other traffic that you wish to change your
direction of travel to the left or right. Press the button again to switch
off the indicators.
Battery status display
The battery status display (fig. 19) shows the charge status. If the
display is in the green range, the battery is sufficiently charged. If the
display is in the red range, the wheelchair can only be used for a short
distance and the battery should be charged as soon as possible (see
charging procedure).
ON/OFF button
Press this button to switch on the wheelchair (fig. 20).
Bischoff & Bischoff GmbH | 05.10.2020 - Revision: 1
TRIPLEX
17
18
19
20
51

Publicité

Table des Matières
loading

Table des Matières