Operating The Product - Dimplex Opti-myst Atherton ATH20-INT Mode D'emploi

Operating The Product

WARNING: FAILURE TO FOLLOW THESE OPERATING INSTRUCTIONS MAY RESULT IN
INJURY AND/OR DAMAGE.
Manual Controls
The manual controls are located beneath the hinged flap at the top of the product. (Fig 2)
is the on/standby button. Press it once to turn on the product. Press it again to turn off the product.
When turned on a 'beep' will sound and the digital display will show
room temperature. The display will then turn off. The fuelbed will light up. Be careful not to look
directly into the fuelbed as the LED lights are very bright. It will take a approximatly 45 seconds
before the flame effect starts.
is the Mode button.
Press it once and you will be in the
the and buttons you can turn the heat on at the LOW or HIGH setting and turn the heat OFF.
You will hear two 'beeps' for LOW heat setting, three 'beeps' for HIGH heat setting and one 'beep'
when the heat is turned off.
Press it a second time and you will be in the temperature set mode
current room temperature and then the set point temperature. Using the
adjust the set point temperature up and down. Note: if the set point temperature is below the room
temperature the heat function will not operate. The temperature range is from 15-35°C
Press it a third time and you will be in the Fire mode. The display will show
current fire effect setting. There are six fire settings. Using the
height of the flame effect.
Press M
Once
Twice
Three times
Remote control
The remote control is supplied with a battery already in place. Simply pull on the clear plastic tab on
the back of the remote control to enable the battery.
• is the on/standby button. Press it once to turn on the product. Press it again to turn off the
product. When turned on you will hear on 'beep' and the digital display will show
by displaying the current room temperature. The display will then turn off. The main LED lights
will activate. Be careful not to look directly into the LED's. These are very bright. Although the
main lights operate immediately it will take a further 45 seconds before the flame effect starts.
• Press once to activate
If you continue to press this button you will cycle through the LOW and HIGH heat settings. You
will heat two 'beeps' for LOW heat setting and three 'beeps' for HIGH heat setting.
• Press once to turn off the heat. You will hear one 'beep'
• Press the button to display the current room temperature followed by the current set point
options. The display will show the current setting. Using
Display Function
Controls the fan
heater
Thermostat
Flame intensity
heat setting. Press it again to activate
followed by the current
. The display will show the
and
buttons you can adjust the
and
Press + or -
Off Low
From 15 °C
From F1 (low)
buttons you can
followed by the
High
To 35 °C
To F6 (high)
followed
heat setting.
6