INFOSEC UPS SYSTEM E4 VALUE 4000 Manuel Utilisateur page 52

16: Floating charger voltage adjustment

Interface
17: Constant charger voltage adjustment

Interface
18: Charger maximum current setting (factory setting, do not modify)

Interface
19: Battery capacity and parallel groups setting (factory setting, do not modify)

Interface
20: Backup time calibration (factory setting, do not modify)

Interface
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
51
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 03 16 AA 59 203 26
Setting
Parameter 2: you may choose Add or Sub to adjust floating
charger voltage.
Parameter 3: the voltage range is from 0V to 6.4V, the default
value is 0V.
Setting
Parameter 2: you may choose Add or Sub to adjust constant
charger voltage.
Parameter 3: the voltage range is from 0V to 3.2V, the default
value is 0V.
Setting
Parameter 3:
E4 Value 4000 / 5000 models : The maximum charging current
could be adjusted as 1A or 2A. Default value is 1A.
E4 Value 5000 B+ / 6000 / 10k models : The maximum charging
current could be adjusted. Default value is 1A. The available
options are 1A, 2A, 4A and 6A. 6A is only available for 16 pieces of
batteries.
Setting
Parameter 2:
Set the battery capacity at 7AH, 9AH, 10AH, 12AH, 17AH, 26AH,
40AH, 65AH, 100AH and so on.
The default value is 9AH.
Parameter 3:
Set the battery group range from 1 to 6. The default value is 1
group. These parameters are for the battery backup time
calculation.
Setting
Parameter 3:
Calibrate the displayed backup time by adjusting this multiplier
factor. The calculation is as below:
Displayed backup time=Original calculated backup time x
Multiplier factor
The default value of the multiplier factor is 1.0, and the range is
from 0.5 to 2.