Lcd Setting - INFOSEC UPS SYSTEM E4 VALUE 4000 Manuel Utilisateur

3-6. LCD Setting

There are three parameters to set up the UPS. Refer to the following diagram.
Parameter 1
Parameter 2
List of 20 programs available for parameter 1:
Code Description
Output voltage
01
Output frequency
02
Voltage range for bypass
03
Frequency range for bypass
04
Reserved
05
Reserved
06
Reserved
07
Bypass mode setting
08
Battery maximum discharge time setting
09
Reserved
10
Reserved
11
12 Reserved
13 Battery voltage Calibration
14 Reserved
15 Inverter voltage Calibration
16 Floating charger voltage adjustment
17 Constant charger voltage adjustment
18 Charger maximum current setting
19 Battery capacity and groups setting
20 Backup time calibration
*Y (YES) means that this program can be set in this mode.
01: Output voltage

Interface
INFOSEC UPS SYSTEM – 4 rue de la Rigotière – 44700 Orvault – France – www.infosec-ups.com
47
Hot Line Tel : +33 (0)2 40 76 15 82 – fax : +33(0)2 40 94 29 51 – hotline@infosec.fr – 03 16 AA 59 203 26
Parameter 3
Setting
Parameter 3: Output voltage
You may choose the following voltage in parameter 3:
208: output voltage is 208VAC
220: output voltage is 220VAC
230: output voltage is 230VAC
240: output voltage is 240VAC
Parameter 1 is for program alternatives. There
are 20 programs to set up. Refer to the table
below.
Parameter 2 and parameter 3 are the setting
options or values for each program.
NOTE: Select "Up3 or "Down" buttons to
change the programs or parameters.
Bypass AC CVCF
Y
Y
Y
Y
Y Y
Y Y Y
Y Y Y
Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Battery Battery Test
Y Y
Y Y
Y
Y Y
Y Y
Y Y
Y Y
Y Y