Machine Usage - Garland FOGGY HOME Manuel D'instructions

5.3. VERIFICATION POINTS PRIOR TO USE
The current supply and its related tension
must be those stipulated on the
characteristics label.
Check the machine and look for lose pieces (screws,
nuts, covers etc) and for any damages. Tighten, repair
or replace the pieces that you have noticed not to be
in a perfect working order. Do not use the machine if it
has lose or damaged pieces.
If the pump works with the internal circuit not full of
water (working in dry conditions), the pump will be
damaged.
5.3.1.- VERIFICATION OF THE ELECTRICAL
CONNECTION
Check that the connection to the mains is correct and
that the electric current is adequate for the machine.
Any attachments must comply with to the needs of
this machine.
Check that the cable is behind the machine and never
in the working area.
5.3.2.- VERIFICATION OF WATER CONNECTION
Open the water intake and check that there are
no leakages. If there are any leakages, replace or
repair the hoses or its connectors.
5.3.3.- PLACEMENT OF THE MACHINE
Ensure the machine is in a vertical and stable
position.
5.4. START UP AND STOPPAGE
Start up: Place the switch in position ¨I.
Stoppage: Place the switch in the ¨O¨ position.
The engine of the machine will stop.
5.5. VERIFICATION AFTER USE
Check that while machine is working, water does
not fl ow out under pressure through the hose or
any connectors.
If you detect any of these leakages please tighten
or repair these parts.
6. USAGE OF THE MACHINE
Use this machine only for its proposed work. The
use of this machine for other jobs not stipulated
in this manual is dangerous and could cause
injuries/damages to the user and to the machine.
Pay particular attention when using this machine
as the fl oor could be wet and there is an obvious
danger of slipping.
Only use original accessories and spare parts
or those recommended by the manufacturer.
Otherwise, damages and/or injuries to machine
and user could happen.
6.1. OPERATING MODE SETTING
This machine has 9 different operating modes to
suit the needs of user.
To set the operating mode, set the microswitches
in the appropriate combination as indicated in the
following table:
27/84
English