Gatorback Mudflaps GCR29F Instructions De Montage page 6

MUD FLAPS:
2. Before you install your Mud Flap Set, see the diagram and parts list for all necessary parts. Start on the driver's
side.
2. Remove factory screw from wheel well hole #9. *Note* Factory screws on holes #7 & #8 will have been removed
during finishing cap installation.
3. Install spring nut (f) on finishing cap hole #12.
4. Loosely install mount clip (h) to mud flap holes #1 & #2 using a cap screw (d) and flat washer (a)
5. Secure mud flap through hole #3 into factory hole #9 using supplied sheet metal screw (e), flat washer (b), and
HDPE flat washer (g).
6. Slide mount clips (h) installed on holes #1 & #2 behind fender lip.
7. Secure mud flap through hole #6 into spring nut (f) on hole #12 using supplied capscrew (d) and flat washer (c).
Loosely secure at this point.
8. Secure mud flap through holes #4 &#5 into finishing cap holes #7 & #8 supplied sheet metal screws (e) and flat
washers (b). Loosely secure at this point.
9. Using a bubble level or other levelling tool, ensure that the mud flap is level. Tighten fasteners.
10. Repeat procedure for passenger side.
Please check out our YouTube channel to see an install video for this application.
THREE FACTORY
SCREWS
f
SUPPLIED REAR
FINISHING CAP
(DRIVER SIDE)
g
b
e
a
d
a
d
c
d
b
e
b
e
Sierra Rear