Gatorback Mudflaps GCR29F Instructions De Montage page 2

INSTALLATION
(For ease of installation it is suggested that the wheel be removed)
FINISHING CAPS:
1. Remove the 4 factory screws from the existing factory guard. Set 2 of these factory screws aside for later
reinstallation. The remaining 2 can be discarded.
2. Because there is no external access to the interior push pin like on the rear guard, the front guard must be pulled
off by hand.
3. Slightly peel back the red 3M tape on the finishing cap and fold back so it can be fully peeled after cap is in place.
4. Position cap, ensuring the top lip of the cap slides under the fender molding as shown.
5. If installing Gatorback Mud Flaps, reinstall the two factory screws on the underside of the finishing cap.
Be careful not to overtighten.
6. Finish peeling 3M tape and press firmly on the bottom and side of the finishing cap to ensure a proper seal.
7. Repeat procedure on passenger side.
FACTORY CAP
FACTORY CAP (GUARD)
Please check out our YouTube channel to see an install video for this application.
REMOVE THE FOUR FACTORY SCREWS
(TWO ON FRONT & TWO UNDERNEATH)
FINISHING CAP
FINISHING CAP (GUARD)
REINSTALL 2 FACTORY SCREWS ON
REINSTALL THE FOUR FACTORY SCREWS
TO THE FINISHING CAP (GUARD)
UNDERSIDE OF FINISHING CAP
Sierra Front