Gatorback Mudflaps GCR29F Instructions De Montage page 3

MUD FLAPS:
1. Before you install your Mud Flap Set, see the diagram and parts list for all necessary parts. Start on driver's side.
2. Remove factory screw from wheel well hole #7. *Note* Factory screws on holes #8 & #9 will have been removed
during finishing cap installation.
3. Install spring nut (h) on finishing cap hole #10.
4. Loosely install mount clip (j) on mud flap hole #2 using a cap screw (a) and flat washer (g).
5. Loosely secure mud flap through hole #5 into factory hole #11 using a sheet metal screw (b) and flat washer (f),
placing a spacer (i) between the mud flap and factory hole.
6. Secure mud flap through hole #6 into spring nut on finishing cap hole #10 using supplied cap screw (a) and
flat washer (d).
7. Slide mount clip (j) installed on hole #2 behind the fender lip.
8. Secure mud flap through hole #1 into hole #7 using supplied sheet metal screw (c) and flat washer (e).
8. Secure the mud flap through hole #3 and #4 into holes #8 & #9 using supplied sheet metal screws (c) and flat
washers (e). Loosely secure at this point.
9. Align the top of the mud flap with the beveled edge of the factory flare. Tighten fastener on hole #1.
10. Using a bubble level or other levelling tool, ensure that the mud flap is level. Tighten fasteners.
11. Repeat procedure for passenger side.
THREE FACTORY FASTENERS
Please check out our YouTube channel to see an install video for this application.
j (DS)
k (PS)
h
i
SUPPLIED FRONT
FINISHING CAP
(DRIVER SIDE)
e
c
g
a
e
c
e
c
f
b
d
a
Sierra Front