turbionaire AMA 60 Manuel D'instructions page 7

• Slide the upper shaft part into the lower one
Attach the shaft bracket to the lower / outer shaft part
Upper / inner
Shaft bracket
Lower / outer
• Place the shaft on the hood body and mark the mounting holes on the wall.
• Remove the shaft and drill the holes at the marked points.
• For exhaust air operation of the hood, attach the exhaust hose to the air outlet of the hood
body.
• Re-attach the exhaust shaft onto the hood body, passing the exhaust hose through the shaft
and connecting it to the exhaust opening if needed.
• Fix the lower shaft bracket to the wall with 2 plugs and screws (4 x 30 mm).
• Pull out the upper/ inner shaft part to the desired height upwards, mark the mounting
holes for the upper shaft bracket on the wall and pre-drill the marked points.
• Fasten the upper shaft bracket with 2 dowels and 2x ST4 x 30mm screws on the wall at
the drilled points.
• Fasten the upper / inner shaft part to the bracket with 2 x ST4 x 8mm screws.
shaft part
shaft part
7