Front View - peerless-AV PP740 Installation Et Montage

Attaching Tilt Knob to Wall Mount (optional)
For tool-less tilt adjustment, replace one 1/4-20 x
4
1/2" screw with tilt knob (D). Drive one 1/4-20 x 1/2"
screw four turns and then remove. Hand thread tilt
knob (D) into wall mount (A) leaving 1/4" exposed
thread as shown in front view.
NoTe: Be sure four 1/4-20 x 1/2" screws have 1/4"
exposed thread.
CAUTIoN
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 20 in. • lb (2.26 N.M.) maximum torque.
• Be careful not to pinch fingers when opening and
closing mount from the wall.
Installing and Removing Flat Panel Display
To attach display to wall mount (A), hook tilt bracket
5
onto four 1/4-20 x 1/2" screws.
WARNING
• Do not lift more weight than you can handle.
Use additional man power or mechanical lifting
equipment to safely handle placement of the display.
Adjust display to desired tilt (15° forward,
5° backward), then tighten four 1/4-20 x 1/2" screws.
Hold display securely to remove from mount. Loosen four
1/4-20 x 1/2" screws and lift display away to disengage tilt
bracket from mount.
A
1/4-20 1/2"
x
SCREWS
9 of 46
REPLACE LEFT OR RIGHT
1/4-20 x 1/2" SCREW WITH TILT KNOB
A

FRoNT VIeW

ISSUED: 01-15-08 SHEET #: 095-9282-7 02-27-14
1/4"
D
1/4"
1/4-20 1/2"
x
SCREWS