Principle Of Operation - MSW VPM-900K Manuel D'utilisation

The distance between the back of the chain toaster and the wall should be at least 20 cm, minimum distance
between the sides of the device and the walls should be at least 10 cm on each side and 35 cm between the
top of the device and the ceiling. Keep the device away from hot surfaces. Operate the device on flat, stable,
clean, refractory and dry surfaces out of the reach of children and people with mental disabilities. Install
the device making sure that constant access to the main plug is ensured. The power cord connected to the
appliance must be properly grounded and should correspond to the technical details. Before the first use,
remove all elements and clean them along with the entire device.

PRINCIPLE OF OPERATION

Control panel view:
1
2
10
1. Manometer showing vacuum level in chamber
2. Emergency stop: stops the operation of the packing machine
3. Control indicator: display the current operation of the packing machine
4. Display
5. Control lights indicating current heat sealing temperature: Three packing seal temperature settings
6. Sealing temperature selector button LOW, MIDDLE, HIGH
7. Button to decrease the current value
8. Button to increase the current value
9. "Sealing" option button: Setting sealing strip heating time required to heat seal the packaging.
10. "Vacuum" option button: time required to establish the required vacuum level in the vacuum packing
machine chamber
Open the top cover of the device; place the packed product in the foil bag inside the vacuum chamber.
The foil bag should be placed with its opening on the sealing strip – see the figures below. Turn on the
device using the main switch (at the back of the machine). Set the desired vacuum, temperature and time
parameters. Close the top cover of the device, vacuum process starts and when it's finished – sealing
process starts. After the processes are finished, the top cover opens automatically and device is ready for
another packaging operation
12
5
4
3
6
9 8 7
Rev. 05.04.2017
Vacuum packing machine rear view:
2
1
3
1. On / off switch
2. Ventilation grille / air pump filter
3. Power / earth cable
Marking bags during vacuum packing:
– Remove gasket from guide in the cover
– Insert the gasket back into the guide in the
cover. Attention! Insert the rubber gasket with
the letters facing downwards!
Oil change in the pump:
Open the vacuum packing machine cover. To do that, unscrew the screw at the front of the machine and lift
the housing up:
Rev. 05.04.2017
– Insert appropriate letters / numbers into
slots in the gasket
– Perform the vacuum packing process.
Remember to place the bag directly under the
letters!
1
2
3
13