HP OfficeJet Pro 6970 Mode D'emploi page 4

Set up fax
You can set up fax using the software wizard (recommended) during the software installation or after installation
using Fax Setup Wizard from the software (Windows) or Basic Fax Settings from HP Utility (OS X), or continue with
the steps below.
1. For users in Europe
If your country or region is listed below, visit www.hp.com/uk/faxconfig for setup information. Otherwise,
follow the instructions in this guide.
• Austria
• Belgium
• Denmark
2. Connect the phone line
Using the phone line for fax only
If a phone cord is provided with the printer, HP recommends that you use this phone cord. If the phone cord is
not long enough, use a coupler and another phone cord to extend.
a. Connect one end of the phone cord to the phone wall jack.
b. Connect the other end to the port labeled 1-LINE on the back of the printer.
Note: DO NOT insert the phone cord into the port labeled 2-EXT.
c. If you have subscribed to a DSL/ADSL service, connect a DSL/ADSL filter between the printer port labeled
1-LINE and the phone wall jack
3. Connect additional devices
If you have other devices to connect, connect them as shown in the diagram below:
5 4
1
8
5
Fax on VoIP**
* TAM: Telephone Answering Machine
** Fax on VoIP: Fax on Voice over Internet Protocol
4
• Finland
• France
• Germany
2
1
3
1-LINE
1
1
1-LINE
2-EXT
1-LINE
10
2-EXT
• Ireland • Netherlands
• Italy • Portugal
• Norway • Spain
1 Phone wall jack
Fax port (labeled 1-LINE) on the back of the printer
2
Note: Do not insert into the port labeled 2-EXT.
DSL/ADSL filter (provided by the telephone company
3
or service provider)
1
1-LINE
2 3
9
7
1-LINE
6
2-EXT
5
• Sweden
• Switzerland
• United Kingdom
1 Phone wall jack
2 Parallel splitter
3 DSL/ADSL modem
4 Telephone answering machine
5 Telephone
6 ISDN wall jack
7 Terminal adapter or ISDN router
8 Broadband modem
9 DSL/ADSL filter
10 Analog telephone adaptor