ITC HD7515 Manuel D'instructions page 19

Use with bag
Change the bag when the one in place is full.
Frequency will depend on the use of the unit.
1. To access the bag, unlatch the two clips and
remove the dust receptacle (figure 12).
2. Remove the used bag and seal bag opening
(adhesive seal provided on each bag).
Discard used bag.
3. Install the new bag, ensuring the tabs on
the bag adaptor are aligned with the slots in
the bag collar (figure 13).
4. Ensure adequate sealing by inserting bag as
far as the retention ring.(figure 14-A).Rotate
bag 20° (figure 14 - B) to ensure tabs on
bag adaptor are no longer aligned with the
slots in the bag collar.
5. Replace dust receptacle and seal by
latching both clips.
Use only genuine Trovac replacement bags.
Failure to do so could void the warranty on
your vacuum unit.
Maintenance
retention
tabs on bag
adaptator
Maintenance
figure 12
ring
figure 13
A
figure 14
B
19