Maintenance; Motor; Carbon Dust Filter - ITC HD7515 Manuel D'instructions

Please note that our motors do not require lubrication. Each motor contains two
carbon brushes that will wear normally, and may eventually require replacement.
For warranty purposes, replacement should be done by an authorized dealer.
Brush life is affected by hours of use, frequency of start-ups and shut-downs,
humidity, altitude, and temperature. In order to avoid damage to the unit's motor,
brushes should be replaced before they are completely worn-out. We therefore
recommend that you have your unit and motors inspected by an authorized dealer
every 5-6 years.
(Patented)
We recommend changing these filters after three
bag replacements or canister emptying. The LCD
monitor will indicate when to change the filters.
These indications are provided by an electronic
timing board only as a reference guide.
To do so:
1. Unlatch the opening on the carbon filter case
and gently flip it upward (figure 9).
2. Remove the used filter, and discard (figure 10).
3. Insert the new filter. When doing so, please
ensure that the arrow printed on the filter itself
points outwards. (figure 11).
4. Close casing opening, and latch.
Part number : TDFILHEC2

Carbon Dust Filter

figure 11

Maintenance

Motor

figure 9
figure 10
17