Bluetooth Pairing - Ledwood LD-T14-TWS Manuel De L'utilisateur

BLUETOOTH PAIRING

Press the multifunction buttons on each earbud for 3 seconds to turn them on. They are au-
tomatically paired when one of the LED indicators turns off while the other continues to flash.
Turn on the Bluetooth on your source device and select «LD-T14» to connect the headphones.
eft
When the flashing LED also goes out, the headphones are connected.
Note: The earbuds are automatically paired with each other when they are turned on. If not,
WS
follow the manual pairing procedure below:
DR
a. Press the multifunction buttons on each of the earbuds until the LED indicator alternately
.3.
flashes red and blue, and a voice message indicates «power on».
HZ
b. Press one of the multifunction buttons for 3 seconds. A voice message indicates «connec-
Bm
ted». The LED indicator of one of the earbuds turns off while the other continues to flash.
le)
The pairing is successful.
mW
c. Turn on the Bluetooth on your source device and select «LD-T14» to connect the earbuds.
-in
When the flashing LED also turns off, the earbuds are connected.
ket
WARNING
Ah
1. If the earbuds have been successfully paired for the first time, there is no need to repeat
Ah
the pairing procedure when using them again.
es
2. If the pairing does not work the first time, deconnect source device, turn off the earbuds
urs
and try again.
urs
urs
BLUETOOTH USE
dB
1. Making phone calls
Hz
Make sure the earbuds are paired correctly with your smartphone before making phone calls.
ms
To answer a call, quickly press one of the multifunction buttons and reject the call by pressing
ble
and holding the same button. When listening to music, redial the last number by quickly
pressing the same button twice.
2. Listening to music
Make sure the earbuds are connected to your smartphone before listening to music. Briefly
press the multifunction button to stop the music and press it again to resume playback.
5