MIA ECO POWER CYCLONE Mode D'emploi page 16

How to clean the filters:
For best results clean or replace the HEPA filter after every second or third use of the vacuum
cleaner, or more frequently if the filter is visibly blocked.
Clean the filter regularly to avoid that the filter becomes clogged and the engine overheated.

1. Remove the waste from the dust receptacle.

2. Open the filter lid. (A)

3. Take the dust separation system from the dust container (B+C).

4. Take the filters from the dust separation system (D).

5. Rinse all filters and the dust separation system thoroughly in lukewarm water.

6. Allow the filters to dry thoroughly.

7. Mount the holders and filters in the reverse sequence.
Please note: Do not lock the second filter (C) to the dust receptacle. This happens automatically
when you place back and lock the lid (A).
Ensure that all parts are completely dry and assembled before using the appliance again.
Water could penetrate into the appliance if the filter is not thoroughly dry. This could result in
damage. Do not clean the filter in a washing machine. Do not dry the filter with a hairdryer.
How to clean the motor filter:

The motor filter is inside the dust box, it is the sponge foam layer. Take the motor filter off
and shake it to remove dust or use a soft brush to clean.
How to clean the air filter:

Open the cover grid of the left wheels by turning it.

Shake and beat it slightly to remove dust or use a soft brush to clean.
How to clean the appliance:

Clean only with a dry or slightly damp cloth or neutral detergent. Don't make wet the vacuum
cleaner. From time to time, the floor brush and all nozzles must be cleaned from longer hair
or lint that might block.
16