Premise FL3 Serie Instructions D'installation page 3

HOW TO MOUNT WITH A SLIPFITTER
Using Slip Fider adachment (FL3-SF, op;onal):
1. Adjust the fixture orienta;on by turning the bolt.
2. Connect wires into wiring terminal; white wire to
"Neutral" terminal, black wire to "Live" terminal, gr
een wire to "Ground" terminal; and fix them by scr
ews. For 208V, connect second live wire to white
wire.
3. Mount the fixture using via the slip fider on a post of
diameter 2.65", then ;ghten with screws.
4. Restore the electricity and check the opera;on of y
our new ligh;ng fixture.
Note: The boBom hole on the slip fiBer is reserved for
sensor installaHon.
HOW TO INSTALL USING MOUNTING ARM
Using Moun;ng Arm adachment (FL3-MA,
op;onal):
1. Open the side cover from the side connec;on.
2. Connect wires into wiring terminal; white wire
to "Neutral" terminal, black wire to "Live"
terminal, green wire to "Ground" terminal;
and fix them by screws. For 208V, connect
second live wire to white wire.
3. Directly screw the fixtures via the moun;ng
arm onto the post using the top hole (the
bodom hole is reserved for sensor
installa;on).
4. If you are installing onto a round pole using
the Round Pole Adapter (FL3-RPA), insert the
longer bolts (provided with FL3-RPA) into the
two moun;ng holes of the Moun;ng Arm,
then through the holes of the Pole Adapter.
Add the appropriate gasket to fit the pole size
(4", 5" or 6"), then secure the bolts.
Tip: The largest gasket is for 4" diameter poles.
5. Restore the electricity and check the opera;on
of your new ligh;ng fixture.
3