Product Safety Information; Product Specifications - Ingersoll Rand 312A Spécifications Du Produit

Product Safety Information

Intended Use:
These Air Orbital Sanders are designed for smoothing and sanding paint, fiberglass, wood
and body filler.
For additional information refer to Safety Information Manual Form 04584967.
Manuals can be downloaded from www.ingersollrandproducts.com.

Product Specifications

Free
Speed
Model
rpm
312A 18000 3.5 X 6-1/3
† K = 3dB measurement uncertanity
pA
‡ K = 3dB measurement uncertanity
wA
* K = Vibration measurement uncertainty
Installation and Lubrication
Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16575516 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator (not if lube-free tool)
4. Emergency shut-off valve
5. Hose diameter
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
The original language of this manual is English.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
04581575_ed3
Pad Sze
inch mm † Pressure (L
88 X 165
Sound Level dB (A)
(ISO15744)
) ‡ Power (L
p
86 97
6. Thread size
7. Coupling and anti-whip device
8. Safety Air Fuse
9. Oil (not if lube-free tool)
EN
Vibration (ISO28927)
m/s²
) Level *K
w
7.7 1.5
EN-1