Status Led; During Installation - resideo CHW3610W Guide De Démarrage

Reset
Use one end of a paperclip to press and hold into the reset hole for
5 seconds to reset WiFi, detector settings, and to re-start Bluetooth
pairing. The LED will blink blue.
Press and hold the paperclip into the reset hole for 15 seconds to
restore factory defaults. The LED will blink blue.

Status LED

The detector has an LED that gives device status.
LED

During installation

Blinking Blue
Solid Blue
Blinking Green
Solid Green
Solid Red
During operation
Blinking Red
In case of an alert
To preserve battery life, it can take up to 1 minute for the detector to
sense a leak.
You can mute the detector by pressing the Mute button in the app or
removing the batteries or cable sensor from the detector. The mute
command may take up to 1 minute to reach the detector.
After you've addressed the cause of the alert, wipe dry the detector and
cable sensor and put them back in place. Replace batteries if they were
removed.
Detector state
Powering up and connecting to Bluetooth.
Paired with Bluetooth.
Connecting to WiFi network.
Has power, WiFi connection, and is operating
normally.
Note: LED turns off after 5 minutes to preserve
battery life.
Failed to connect to WiFi.
Detected a leak.
7