Publicité
MOTION SENSOR INSTALLATION: Slip-Fitter Long Arm Mount
Punch out the motion sensor knock-out on the slip-fitter long arm bracket with a hammer. Follow STEPS 1 & 2 on page
7. Install motion base and waterproof gasket on the slip-fitter long arm bracket, then tighten screws. Screw the Screw the
microwave or infrared sensor into sensor base. Follow STEPS 3 & 4 on page 7 to complete installation.
NOTE: See page 10 for motion sensor wiring diagram.
INSTALLATION: Fixed Adapter Arm Mount
STEP 1: Unscrew the screws with a screwdriver,
remove the iron bar, press junction box cover of fixed
adapter arm bracket to open it.
STEP 3: Pass the fixture's AC input wires through the
fixed adapter arm bracket.
STEP 5A: Pass the fixture's AC input wires through the
pole, pull them out together at top of pole and prepare wire
connections. Go to STEP 6A on page 9.
STEP 2: Put the iron bar inside of pole, fix it with a screw,
but reserve a gap of 32mm, pass the fixed adapter arm
bracket through the screw and tighten. Pass the second
screw through the hole of fixed adapter arm bracket, pole
and Iron bar, then tighten with a wrench.
STEP 4: Hang the fixture on fixed adapter arm bracket.
Lock the fixture by tightening screws through bracket
with an allen wrench.
NOTE: When installing to a round pole, remove the
prominent rubber gasket. Keep the flat rubber gasket.
STEP 5B: Pass the pole wires into the fixed adapter
arm bracket, pull them out together with fixture's AC
wire from junction box. Connect the fixture's AC input
wires to pole wires with connectors. L to L (Black),
N to N (White), PE to PE (Green). Go to STEP 6B on
page 9.
8
Publicité
