Satco NUVO 65/674 Instructions D'installation

CCT SELECTABLE SEMI CUTOFF
LED WALL PACK
Models: 65/674, 65/675, 65/676
INSTALLATION AND SAFETY INSTRUCTIONS
IMPORTANT: Read before installing fixture. Retain for future reference.
WARNING:
Risk of Fire or Electric Shock
• To reduce the risk of fire, electrical shock or injury to persons; read and follow all warnings
and installation instructions before installing.
• All installation should be performed by a qualified electrician.
• To avoid electric shock, ensure power is turned off before installation or inspection.
All wiring must be installed in accordance with Electrical Code and local electrical code.
• To prevent fire, this fixture is rated for use in 120-277V, 50-60Hz protected circuit and
105°C rated supply wire.
• To prevent product malfunction and/or electrical shock, this product must be properly
grounded.
• To avoid damage and/or product malfunction, do not modify the fixture or replace
accessories without confirming with the supplier first.
• To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
• Suitable for wet locations.
IMPORTANT:
This product must be installed in accordance with the applicable installation code by a person familiar with the
construction and operation of the product and the hazards involved.
CCT INSTRUCTIONS
STEP 1: Remove screws with screw driver,
unscrew the upper part from fixture.
STEP 2: Open fixture, set up CCT through inside
DIP Switch, default switch gear is 4000K, dial
downward for positioning 3000K, dial upward for
5000K, dial to middle for 4000K. Users can dial
to positions for the CCT needed.
STEP 3: Close the fixture after selecting CCT,
tighten the upper part to the back cover with
screws, CCT adjustment is done.
INSTALLATION
STEP 1: Use a screwdriver to unscrew the lamp
screws and remove the upper part of the fixture.
STEP 2: Unscrew the cover of the entry hole on
the lamp base and remove the cover.
STEP 3: According to the embedded terminal
box, punch the corresponding mounting hole
on the light's mount.
STEP 4: Tear off the adhesive paper of the
waterproof pad and stick the waterproof pad
to the lamp base.
STEP 5: Put the input line and dimming line
from the embedded junction box through the
lamp base and then screw the lamp base to
the embedded junction box.
STEP 6: Install the upper half of the fixture on
the lamp base, then use the threaded terminal
to connect L, N, ground wire, dim+ and dim–
separately. Next, plug the threaded terminals
into the embedded junction box.
STEP 7: Close the lamp body and tighten with
screws to complete the installation.
© Copyright 2020 Satco Products, Inc. 5/20
SALE on SATCO at www.BulbAmerica.com
take additional 5% Off with coupon code 5PDF
1
3
1
3
5
7
Dimensions
320mmW x 148mmH x 133mmD
2
2
4
6
Satco Products, Inc.
Brentwood, NY 11717