Télécharger Imprimer la page
Thetford Sanicon Turbo 500 Guide Rapide
Thetford Sanicon Turbo 500 Guide Rapide

Thetford Sanicon Turbo 500 Guide Rapide

Masquer les pouces Voir aussi pour Sanicon Turbo 500:

Publicité

Liens rapides

Parts A
A2
New
Ref.
Description
A
-
Pump Assembly
Tools Needed:
■ Phillips screwdriver
■ Pliers
■ Flat blade screwdriver
■ Some installations may require other tools.
Thetford Corporation recommends that only a trained
AVISO
AVIS
!
NOTICE
CAUTION
and qualifi ed technician service this product.
The pump is suitable for indoor and outdoor use.
NOTICE
Remove Part
Use
OLD PARTS:
1. Disconnect power. See Fig. 1.
2. Ensure all gate valves are closed.
3. Disconnect all plumbing attached to
may vary.
4. Remove mounting hardware
5. Remove
(assembled) from coach. Discard.
A
Replace Part
Use
.
NEW PARTS
1. Secure
in place with mounting hardware from coach (Step 4
A
above).
2. Reconnect all fi xtures to
Refer to Fig.1.
3. Reconnect power. See Fig. 1.
4. Use gray tank to test for leaks.
P.O. Box 1285
Ann Arbor, MI 48106
www.thetford.com
Pump Assembly Kit
A1
and
. Installations
A1
A2
set aside.
;
and
. Installations may vary.
A1
A2
Questions? 1-800-543-1219
Part No.
N
Pieza núm.
A
Thermal Cut-Off Switch
Because SANICON® Turbo pumps are designed for intermittent
duty, the pump contains a thermal cut-off switch for your safety.
Typical run time is 15-20 minutes of operation before the thermal
shut-off switch turns the pump off. After 20 minutes, the thermal
cut-off switch will reset and allow the pump to run again.
■ If the pump is run immediately after a thermal reset, it will run
for approximately five - eight minutes.
■ If allowed to cool for several hours it will run the full 20 minutes.
Pump Performance
Performance varies with hose size and length:
Hose
& Length
®
SANICON
hose 1.5" x 21'
®
SANICON
hose 1.5" x 21'
®
SANICON
hose 1.5" x 21' w/ 100'
3/4" garden hose
®
SANICON
hose 1.5" x 21' w/ 100'
3/4" garden hose
®
SANICON
hose 1.5" x 21' w/ 50'
3/4" garden hose
Thermal cut-off will occur after 20 minutes. Refer to
i
"Thermal Cut-Off Switch" discussion.
1
o
de pièce
Made in the U.S.A.
Fabriqué aux É.-U.
Hecho en EE.UU.
Height
Flow Rate
(gal/min)
9'
11.1
0
18.7
9'
0.7
0
3.7
0
6.2
97541 Rev. B 07/05/17
97540
Minutes to
Empty 100
Gallons
9
5
143
i
27
i
16

Publicité

loading

Sommaire des Matières pour Thetford Sanicon Turbo 500

  • Page 1 ■ If the pump is run immediately after a thermal reset, it will run ■ Some installations may require other tools. for approximately five - eight minutes. Thetford Corporation recommends that only a trained ■ If allowed to cool for several hours it will run the full 20 minutes. AVISO...
  • Page 2 ■ Pinces ■ Destornillador plano ■ Tournevis à lame plate ■ Algunas instalaciones podrían requerir otras herramientas. ■ Certaines installations peuvent exiger d’autres outils. Thetford Corporation recomienda que las labores de Thetford Corporation recommande que seul un tech- NOTICE AVISO ATTENTION...
  • Page 3 Interrupteur thermique Interruptor de corte térmico Puisque les pompes SANICON® Turbo sont conçues pour Ya que las bombas SANICON® Turbo están diseñadas para un une utilisation intermittente, elles comportent un interrupteur funcionamiento intermitente, la bomba contiene un interruptor de thermique pour votre sécurité. Leur temps de fonctionnement corte térmico como mecanismo de seguridad.
  • Page 4 Wiring Diagram Schéma de câblage Diagrama de cableado Thetford Recommended Schéma de câblage recommandé par Diagrama de cableado recomendado por Wiring Diagram Thetford Thetford Your installation in the coach Votre installation dans le Su instalación en el vehículo AVIS AVISO NOTICE may vary.

Ce manuel est également adapté pour:

97540