Cleaning And Maintenance - VALBERG CYCLONIC-H2 Consignes D'utilisation

C

Cleaning and maintenance

Cleaning and maintenance
WARNING!
• To prevent the risk of electrocution, turn off and unplug
the unit from the power supply before cleaning.
• Never immerse the unit in water or any other liquid.
• Do not immerse the vacuum (main body) or USB
charging cable in water or any other liquid, as they
contain electrical components. Do not rinse them under
a tap.
• Never use solvents, chemical or abrasive cleaning
products, wire brushes, sharp objects or scouring pads
to clean the unit.
Cleaning the exterior of the unit
• Detach the 2-in-1 nozzle from the vacuum.
• Clean the unit with a soft, slightly damp cloth. Make sure that
no liquid enters the unit.
• After cleaning, dry the unit thoroughly.
Cleaning the dust cup and filters
Clean the dust cup after each use or when it is full and has reached
the MAX mark. Clean the HEPA and metal filters when they are
full, there is a loss of suction or every three months.
Press the dust cup release button and remove the dust cup (from the main body).
Empty any dirt found within the dust cup into a bin.
Turn the metal and HEPA filters anticlockwise towards the unlock symbol
them. (To reattach the metal or HEPA filter, align the dot on the respective filter with the
unlock symbol,
and clicks firmly into place.)
Pull the HEPA filter to remove it.
then turn it clockwise until the dot lines up with the lock symbol
18 EN
to remove