Product Usage; Charging The Battery - VALBERG CYCLONIC-H2 Consignes D'utilisation

B

Product usage

Charging the battery

The battery must be charged before first use and whenever the vacuum will not turn on
because the battery is too low.
NOTE:
• When the power is too low and the battery needs to be charged, the indicator
light will flash for 10 seconds and the vacuum will automatically turn off.
• Always make sure that the appliance is turned off before charging.
1. Insert the micro USB-C connector into the micro USB socket on the underside of
the vacuum.
2. Insert the USB connector into a USB port, such as one on a computer, car or USB
charging plug adaptor. Make sure the port's rated power output is 5 V DC/2-4 A.
• It takes up to 4 hours to fully charge the battery.
• The Power button's battery LED indicator displays the battery status as follows:
LED indicator Meaning
Flashes The USB cable is connected, and the battery is charging.
The Power button is on and the battery is low (less than 10%).
Constant The battery is fully charged
(After 5 minutes of being fully charged, the LED will turn off.)
• Once fully charged, the vacuum has a usage time of approximately 14 minutes.
• To ensure the longevity of the battery and the product's lifespan, recharge the vacuum
whenever the battery is dead, even if you do not plan to use it.
WARNING!
• After charging, always unplug the USB cable from the vacuum and USB socket.
• Do not charge the battery at temperatures below 0°C or above 40°C.
16 EN