Electrical Connection; Setting The Operating Modes - Versions With Single-Color Led (Without External Control) - Pfannenberg PY L-S Mode D'emploi

en
6.2

Electrical connection

➢ Observe the
Safety
Circuit board in lower part:
Operating voltage
connection
Operating voltage
connection
Note: Devices with DC voltage are equipped with reverse polarity protection. No function if the polarity of the
connections is reversed.
7.1

Setting the operating modes - versions with single-color LED (without external control)

Circuit board in the lens:
S1
Selection of
operating mode
S1
Operating mode
1 2 3
OFF OFF OFF Flashing light 1 Hz
OFF OFF ON Flashing light 0.75 Hz
Continuous light
OFF ON OFF
OFF ON ON Blinking light
Flashing light 2 Hz
ON OFF OFF
Blinking light
ON OFF ON
ON ON OFF Flashing light 0.1 Hz
Flashing light 0.5 Hz
ON ON ON
OFF OFF ON Double Flash mode (DFM3) see
09/2022
information!
AC:
DC:
AC:
DC:
*
1 Hz
2 Hz
Operating instructions PY L-S
PY L-S with single color LED
Connecting cables:
PY L-S with multicolor LED (RGBW)
Light intensity control
Flashing light: 10 – 100%
Blinking- / Continuous light:
*
Option
Page 5 / 8
45 – 100%
Factory setting
086200015d