Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
7. Install hitch – Using the supplied pullwires
leave pullwires attached. Make sure weldnuts are free from rust and debris. Raise the hitch into position and align holes in hitch bracket to the frame rail weldnuts
guiding the pullwire ends through holes in the hitch bracket and loosely reinstall the M16 bumper bolts removed in step 4. Remove pullwires, install conical
washers
(teeth side toward hitch) and nuts
8. Tighten all M16 fasteners with torque wrench to 146 Ft.Lb. (198 N*M), 1/2" fasteners to 75 Ft.Lb. (102 N*M)
©2019 Horizon Global™ Corp - Printed in Mexico
install the carriage bolts ①and spacers ② into the vehicle frame through the forward attachment, see Fig. 4,
, see Figure 1.
⑤
Kink pullwire to keep spacer independent of
bolt
A. Insert bolt and
B. Align block
Block into
on
frame
access hole
Figure 4
Proper torque is needed to keep the hitch secure to the vehicle when towing.
C. Pull bolt
thru block
Sheet 10 of 33
36787NP
8-8-19
Rev. A
Publicité
Table des Matières
