Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Fiche technique
ET 04380
LITTLE
WONDER
BLOWER
STORAGE
To prevent possible explosion or ignition of vaporized
fuel, do not store equipment with fuel in tank or
carburetor in an enclosure with open flame (for example,
a furnace or water heater pilot).
Before the equipment is put into storage for any
period exceeding 30 days.
1. Drain all fuel from the fuel tank and fuel lines.
2. Start the engine and run until all the fuel is used
from the carburetor float bowl and the engine
stops.
3. While the engine is still warm, drain the crankcase
oil and replace with the proper weight oil
corresponding to the season the equipment will be
next used.
4. Remove the spark plug and squirt a small amount
of engine oil into the cylinder. Slowly pull the
starter a few times to distribute oil in the cylinder
and reinstall the spark plug.
5. Top off if necessary. See engine manual for
details.
TORQUE SPECIFICATIONS
Location
Housing to engine face
Engine to deck
Fan to Crankshaft
PROTOUMAT - 35 route de Colmar, 67600 Sélestat
SIRET : 444 448 898 00015
STORAGE / TORQUE SPECIFICATIONS
Description
BLT-W LF 5/16-24 x 1-3/8
BLT 5/16-18 X 1-1/2
BLT-HEX 7/16-20 x 1-3/4 GR8
(USED ON 9270 MODELS)
BLT-HEX 3/8-24X1-3/4 GR8
(USED ON 9390 AND 9400
MODELS)
BLT-HEX 3/8-24 X 2.5 GR 8
(USED ON 9570 MODELS)
To put the equipment into service after an extended
period of storage.
1. Check for loose parts and tighten if necessary.
2. Fill the fuel tank and then check the engine oil
level.
3. Start the engine and check for fuel leaks. Repair
any leaks before operating the unit.
Min. Torque
P/N
Ft-lbs (In-lbs)
910517
22
64262-009
19
50
64123-253
64123-127
57
30
64123-267
Tél. : 03 88 08 65 06
Fax : 03 88 08 67 39
Max. Torque
Ft-lbs (In-lbs)
28
25
90
63
50
19
contact@protoumat.fr
61
www.protoumat.fr
Publicité
Table des Matières
