Set Up Instructions - Little Wonder OPTIMAX 9270-12-01 Manuel Du Propriétaire

Fiche technique
ET 04380
LITTLE
WONDER
BLOWER
SET-UP INSTRUCTIONS
1. Open box. Remove upper handle and cardboard
insert.
2. Cut the back of the box open. Use lower handle to
roll unit out of the box.
3. Locate hardware package.
4. Install upper handle to lower handle with (4) 3/8-16
x 1-34 carriage bolts and (4) 3/8-16 flanged nylon
insert nuts from the hardware package. Tighten
the nuts securely but not so much as to crush the
tube. (Figure 1) NOTE: There are two handle height
positions to choose from.
5. Route the throttle cable in front of lower handle
crossbar. Install to the left side of the upper handle
with (2) 10-32 x ½ thread forming screws from the
hardware package. (Figure 2)
6. Ensure the center link of the chain is on the center
tooth of the deflector sprocket before connecting the
deflector cable. (Figure 3)
7. Route the deflector cable in front of the lower handle
cross bar. Remove one of the nuts and the bolts
from the end of the deflector cable and install the
cable through the key slot into the bracket on the
upper handle and reinstall nut and bolt. Move the
clevis from the control lever and install over the end
of the cable. Reconnect the clevis to the control lever
with a ¼ x 5/8 clevis pin and hairpin cotter. (Note:
The deflector can be moved and held in place with
the locking knob to help connect the clevis fitting
to the control lever. Move the control lever to the
rear to more easily connect the cable. Loosen the
knob so the deflector moves freely after the clevis is
connected.) (Figure 4)
PROTOUMAT - 35 route de Colmar, 67600 Sélestat
SIRET : 444 448 898 00015
FIGURE 4
SET-UP INSTRUCTIONS
FIGURE 1
FIGURE 2
FIGURE 3
Tél. : 03 88 08 65 06
Fax : 03 88 08 67 39
9
contact@protoumat.fr
51
www.protoumat.fr