Table des Matières
Publicité
Position
slots
Edges of radiant
to fit in slots on
supports
Radiant
Cooking grate
Operation
Turn the burners on about 15-20 minutes before cooking and allow the unit
to preheat. Set the knobs to the desired flame height. Each valve will control
the gas flow to the burner to bring that area of the unit up to temperature. If
different temperature settings are to be used, adjoining areas should be set at
progressively higher temperatures, using the lowest temperatures on the outside
burners. A uniform and systematic approach to the use of the unit will produce
the most consistent product results.
Radiants
Burner
Place the radiants in position as shown. Make sure that the radiants are set properly
into the slots on the front and rear supports. Radiants should be centered over the
straight section of the burners.
Cooking Grates
Place the top cooking grate with the grid bars sloping toward the front as shown.
NOTE: When cooking grates are placed sloping toward the front, the grooves on top
will guide the excess fat drippings into the grease trough.
Operating Instructions
OM-LCB
11
Publicité
Table des Matières
