Cramer 1400486 Mode D'emploi page 8

• To avoid overheating and damage to the motor or the battery, always keep
EN
the cooling air vents clean and free of debris.
Cleaning the chain
Remove any traces of sawdust or oil deposits from the chain every time it is
used.
If there is excessive dirt or resin build-up, disassemble the chain and place it in a
container with a specific cleanser for a few hours. Then rinse it with clean water and
treat it with a suitable anticorrosive spray, before reassembling on the machine.
STORAGE
Storing the product
When the machine is to be stored away:
1
Remove the battery from its housing and recharge it;
2
Mount the bar cover.
3
Wait until the motor is sufficiently cold;
4
Clean.
5
Check there are no loose or damaged components. If necessary, replace
the damaged components and tighten any screws and loose bolts or
contact the authorised service centre.
6 Store the machine:
•
– review the ambient temperature chart for information on storage
temperature.
• – in a dry place
•
– protected from inclement weather
• – in a place where children cannot get to it
• – making sure that keys or tools used for maintenance are removed.
8
cramer.eu
All manuals and user guides at all-guides.com
Troubleshooting
PROBLEM
Pole saw
fails to
operate.
Bar and
chain
running
hot and
smoking.
PROBABLE CAUSE POSSIBLE SOLUTION *
The poles are not assembled Reassemble the poles according
correctly. to the instructions.
No electrical contact To secure the battery, make
between the pole saw and sure the latches on the battery
battery. compartment snap into place.
The battery pack is Charge the battery pack.
depleted.
The lock-off lever and Press down the lock-off lever and
trigger are not depressed hold it, then depress the trigger to
simultaneously. turn on the pole saw.
The battery and power tool Refer to the battery and charger
is too hot or too cold. maintenance part in the manual.
No oil in the oil tank. Refill oil into the oil tank.
The discharge port is blocked Refer to the manual to remove
by debris. the bar and clean out the debris.
Inlet opening in inner oil tank Clean the oil tank, and refill with
is blocked by debris. clean bar and chain lubricant.
The sprocket is stuck and Clean the sprocket and refill with
clogged with debris. clean bar and chain lubricant.
Chain tension for Refer to Re-tensioning the saw
overtightened or loose chain in the manual.
condition.