Before Using Your Appliance; Installation Of Your Appliance - AIRLUX ARCAV54 Manuel D'instructions

INSTALLATION

BEFORE USING YOUR APPLIANCE


Remove all exterior and interior packing. Clean
the interior surface with lukewarm water using a
soft cloth. The unit may have residual odors at
first, they will disappear as the unit cools.

Before connecting the appliance to the power
source, let it stand upright for at least 24 hours.
This will reduce the possibility of a malfunction in
the cooling system caused by handling during
transportation. During this time we recommend
that you leave the door open to clear any
residual odors.

The door on this appliance can be opened from
either the left or the right side. The unit is
delivered with the door opening on the left side.
Should you wish to open the door from the right,
follow the instructions 'Reversing the door
hinge'.

Install the handle on the door if necessary.

INSTALLATION OF YOUR APPLIANCE


The appliances are designed to be built-in or
recessed or free standing installation.

WARNING: Do not store or install the appliance
outdoors. The unit is for indoor use only.

WARNING: Do no install the appliance in the
laundry. Avoid locating the unit in damp areas.

Place your appliance on a floor that is strong
enough to support it when it is fully loaded. To
level your unit, adjust the front leveling leg at the
bottom of the unit.

For freestanding installation, 100mm of space
between the back and sides of the unit are
suggested, which
circulation to cool
condenser for energy saving. Even for built-in
installation, it is a must to keep 5mm space on
each side and at the top to ensure proper
service access and ventilation. Take care that
the air vent at the front of the appliance must
never be covered or blocked in any way.

Locate the unit away from direct sunlight and
sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and
heat sources
consumption. Extreme
temperatures may also cause the unit not to
perform properly.

Plug the unit into an exclusive, easily accessible
plug socket. Any questions concerning power
allows the proper
the compressor
may increase electrical
cold ambient
and/or earthing should be directed towards a
qualified electrician or an authorized products
service centre.

The appliance must be installed to all electrical,
plumbing, water and drain connections in
accordance with state and local codes.

IMPORTANT:
During
condensation may appear on outside surfaces of
glass door. This condensation will disappear
when humidity levels drop. For prevention, it is
advisable to install the appliance with sufficient
ventilation in a dry and/or an air-conditioned
place.
NOTE: The appliance must be positioned so
that the plug is accessible.
BUILT-UNDER INSTRUCTIONS
Make sure your installation does not block the front
ventilation grille. If the unit is installed for fitting
kitchen plinth, make sure that the ventilation gaps in
the plinth are at least 300 square centimeters and
remove the ventilation grilles, so that warm air can
disperse unhindered. Otherwise the appliance has
to work harder, resulting in an increase in electricity
consumption.
NOTE: When pushing the appliance into the niche,
make sure that the mains cable does not get
trapped.
air
and
15cm
Wide
30cm
Wide
60cm
Wide
25
HIGH HUMIDITY
periods of high humidity,
A B C
(mm) (mm) (mm)
148 150 75
295 300 110
595 600 110
CLIMATE.
some
D
(mm)
450
460
460