Hama Smart Grip 2 Mode D'emploi page 3

G Operating instruction
Thank you for choosing a Hama product.
Take your time and read the following instructions and
information completely. Please keep these instructions
in a safe place for future reference. If you sell the device,
please pass these operating instructions on to the new
owner.
This product has been developed specifically to provide
your mobile device with energy while you are on the go
without requiring a power supply or a power supply unit.
1. Explanation of Warning Symbols and Notes
Note
This symbol is used to indicate additional information
or important notes.
2. Package Contents
• Smartphone Holder
• These operating instructions
3. Safety Notes
• When using this product, observe the applicable local
traffic laws and regulations.
• Take care that components such as airbags, safety
areas, controls, instruments, etc. and visibility are not
blocked or restricted.
• Do not allow yourself to be distracted by the product,
for example when driving a vehicle or operating sports
equipment. Always pay attention to the surrounding
traffic and your environment.
• Never apply force when using the product or during
installation.
4. Installation
Note
Before mounting the holder, check the installation
options in your vehicle. If in doubt, consult the
manual for your vehicle or contact the manufacturer.
2
• Insert your smartphone by pushing holding arm A
(1) together with the smartphone upwards (2). The
holding arm is spring-mounted meaning that your
smartphone should now sit firmly in the holder.
• If your smartphone is wider than 6.5 cm, you will need
to adapt holding arm B (3) beforehand. To do so, press
button C (right-hand arm, right-hand button) and keep
it pressed while pulling the holding arm to adjust it.
• To mount the holding arm to the windscreen, open
lever E (4), press the suction cup on to the windscreen
and close the lever again.
• The ball joint allows the holder to be rotated 360°.
To set the ideal viewing angle, undo setting wheel D
(5), adjust the holder and tighten the setting wheel
again. Always ensure that the setting wheel is firmly
tightened before beginning your journey.
5. Care and Maintenance
Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
6. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides
no warranty for damage resulting from improper
installation/mounting, improper use of the product or
from failure to observe the operating instructions and/
or safety notes.
7. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com