Mounting The Wall Bracket - Harrie Leenders Dia Instructions D'installation

3. Positioning the wall bracket
• Determine the centre of the wall bracket.
• Drill the upper hole at 712mm from the floor using a Ø 6mm masonry bit.
• Use the wall bracket as a template and a spirit level to drill the other 5
holes using a Ø 6mm masonry bit.
• Ream the 6 holes using a Ø 14mm masonry bit.
5. Hanging the stove
• Place sliding pieces underneath the transport brace.
• Push the stove against the wall bracket so that the oblong holes slide
over the eyes. Be careful not to damage the floor.
• Place the 2 cotters into the eyes with the opening towards the front.

4. Mounting the wall bracket

• Mount the wall bracket using the expansion-shell bolts.
• Affix 2x flat tape on the vertical strips of the wall bracket.
6. Removing the transport brace
• Remove the 4 bolts from the transport brace using
a socket-head wrench 6.
• Remove both legs from the transport brace.
GB 19