Battery Installation; Charging Your Battery - Qstarz BT-Q818XT Guide D'installation Rapide

English
................................................................................................................................................................................................................
C. Battery installation
C‐1 Put Battery in place: Press the PUSH button on the bottom side
of the unit (1) and pull out the battery cover. Insert battery in the
unit (2) and put battery cover on to the cabinet (3), then push down
and force it forward to fit firmly (4).
C‐2 Take Battery out: Press the PUSH button on the bottom side of
the unit (1) and pull out the battery cover (2). Then take out the
battery from the unit (3).
D. Charging your battery
For the first time using the
BT‐Q818XT, please charge battery
until it is fully charged. Take the
power cable and connect it to the
power jack (mini USB type) and
recharge through travel charger or
car cigarette adaptor. This will begin to charge the battery. Charging
time is 3 hour typically.
‐ When the Power LED is Red, battery power is low status. Please
recharge.
‐ When the Power LED is Green, the battery is under charging mode.
‐ When the Power LED is off, the battery is fully charged.
E. Start to use
E‐1 Getting satellite fix with Q818XT
Q818XT is built in GPS module which needs to be used in outdoor
environment. When switch on your Q818XT, the GPS will start to
acquire the satellites position. Once the GPS position is fixed, GPS
LED will be flashing.
E‐2 Activate the Bluetooth function in your PDA/Smart phone or
.........................................................................................................................................................................................
2 www.Qstarz.com