To Avoid Breakage - Samsung NY63 875 Serie Manuel D'installation

To avoid breakage

Install_NY63T8751S_DG68-01305A-01_EN+CFR.indb 13
CAUTION
Please DO NOT push the unit strongly when
you install. These actions can cause the
damage to the unit.
Please DO NOT push the burner knobs when
installing the range.
(Grasp the L/R door area to push the unit.)
Do not grasp and push handle when you
install.
CAUTION
Do NOT lift or handle the unit by the cooktop frame.
Fig. 1
1. The counter top around the cut-out
should be flat and leveled (See hatched
area on Fig. 1).
2. Before installing the unit, measure
the heights of the two cabinet sides
(C1 ~ C4), front and back (See Fig. 1)
from the floor to the top of the counter.
Level the range using the four leveling
3.
legs so that the height from the floor
to the underside of the cooktop frame
is greater than the tallest cabinet
measurement by at least 1/16".
Slide the unit into the cabinet (DO NOT
4.
PUSH THE UNIT HARD). Make sure the
center of the unit aligns with the center
of the cabinet cut-out.
5. The metal flange under each side of
the cooktop MUST be placed over the
cabinet countertop for proper unit
support. The cooktop should NOT rest
directly on the countertop or else it
could cause damage to the cooktop
voiding the warranty. Level the unit if
needed.
English 13
2020-07-20 4:47:30