Bosch Sensixx'x DA50 Notice D'utilisation page 17

Trouble shooting
Problem Probable cause
The iron does not 1. Temperature control (12) set to
heat up.
2. The "secure"* system has been
The clothes tend 1. The temperature is too high.
to stick
Water drips out of 1. Temperature control (12) setting
the soleplate (7)
together with
steam. 2. Steam regulator (3) is set too
3. You have pressed the shot of
Steam does not
1. Steam regulator (3) is set to
come out.
2. The temperature is too low.
Smoke comes out 1. This may be caused by the
when connecting
the iron for the first
time.
Excessive dripping 1. No proper closing of
or steaming.
Deposits come out 1. Traces of lime scale are coming
through the holes
in the soleplate
(7).
If none of the above solves the problem, get in touch with an authorised technical service.
* Model dependent
minimum.
activated ("auto off" indicator
lamp 15* flashes). The iron is set
to stand-by.
is too low.
high in conjunction with a low
temperature.
steam button (2) repeatedly
without waiting for 5 seconds
between each press.
position.
Anti-drip system is activated.
lubrication of some of the internal
parts.
"Calc'nClean" system.
out of the steam chamber.
Solution
1. Turn to a higher position.
2. To reconnect the iron, just move it about
gently.
1. Turn the temperature control (12) down
and wait until the iron has cooled down.
1. Turn the temperature control to a higher
setting (between "••" and "max") and wait
until the light (13) goes out.
2. Set the steam regulator (3) to a lower
setting.
3. Wait 5 seconds between each press of
the shot of steam button.
1. Set the steam regulator to a higher
position.
2. Set to a higher temperature if compatible
with the fabric.
1. This is normal and will stop after a few
minutes.
1. Actuate a few times the "clean" button
(10).
1. Carry out a cleaning cycle
(see "Calc'nClean" section).
17
BOS CH