Operating Instructions; Power On; Power Reset; Power Off - Vigor Equipment V2795 Mode D'emploi

Operating Instructions

1. Power On

Press "C" to Power on, Electronic Angle Gauge V2795 enters Setting Angle
Environment.

2. Power Reset

Press "C" for 3 seconds to reset the Electronic Angle Gauge V2795.

3. Power Off

Auto shut off after 2 minutes non-usage.

4. Clear

Press "C" to clear reading value and return to preset angle value.
The Electronic Angle Gauge V2795 will save reading value.

5. Angle measure Environment

5.1. Floating Preset Mode
Step 1. Press "C" button to Power On.
Step 2. A fter power on , press the "UP" key to increase the angle value.
Step 3. P ress the " Down" key to decrease the angle value.
5.2. Measure Mode
Step 1. Press "+" key, begin to accumulate angle.
Step 2. In measure mode, the Electronic Angle Gauge V2795 will auto-
matically detect direction and the LCD display shows actual
applied angle value.
Step 3. R everse the opposite over 5°. The LCD display flashes and stops
accumulating angle.
Step 4. F orcing the wrench and hold on the same direction. Press "+" key,
begin to accumulate angle.
Step 5. For Add-up 2nd movement, go back to the start point, and force
slightly to remove the backlash of tool. Then press "+" key,
to accumulate and add up the angle summary together with
1st movement.
10