Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
First use
• Remove the device and accessories from the box. Remove any stickers, protective film or plastic from the
device.
• Before you use the device for the first time, clean the base with a damp cloth and rinse all the removable parts
with a soapy water.
• Thoroughly dry the base, and all removable parts.
• Never use aggressive or abrasive cleaning materials, a scouring sponge or steel wool; these damage the
device.
• Place the popping chamber
• Place the device on a flat, stable surface, in a place where it cannot fall over.
• Make sure that the power switch
• Connect the device to the mains power.
Power ON/OFF
• Make sure the power plug is connected to the mains power.
• Power on the device by switching the power switch
• The device will heat up instantly, preheating is not necessary.
• To power off the device, switch the power switch
• Then remove the power plug from the mains power.
Cooking
• Before each use, make sure the top cover
• Place the device on a flat, stable surface, in a place where it cannot fall over.
• Make sure that the power switch
• Take the top cover (with integrated measuring cup)
with corn kernels. Do not overfill (MAX mark) the measuring cup!
• WARNINGS!
o Only use dry corn kernels.
o DO NOT USE MICROWAVE POPCORN.
o Do not put ingredients like sugar, oil, butter, salt, margarine etc. in the aluminium cup of the
main body or popping chamber. Such substances will stick to the aluminium cup or popping
chamber and will damage the device.
• Empty the measuring cup through the top of the popping chamber
.
3
• Place the top cover
• CAUTION! Beware of scalding as a result of escaping steam. During cooking, moisture of the
corn kernels can turn into steam. Turn the corn outlet away from you, so that steam will not come into contact
with your skin.
• Place a large heat-resistant serving bowl underneath the corn outlet of the popping chamber
edge of the serving bowl against the casing
corn outlet into the serving bowl and is not re-directed, blocked or otherwise interfered with.
• Power on the device by switching the power switch
• The device will heat up instantly, preheating is not necessary.
• After a few moments, the corn kernels will turn into popcorn due to the heat and will be ejected in the serving
bowl via the corn outlet of the popping chamber
• WARNING! The air and popcorn ejected from the corn outlet will be hot. Do not block the corn outlet with
body parts (such as hand or fingers), as this can cause burns.
• To prevent the device from overheating, do not use the device for more than 5 minutes while cooking the
popcorn.
• To prevent the device from overheating, wait ± 10 minutes between each consecutive quantity of popcorn.
• Use a paper towel to remove all residues from the popping chamber
of popcorn.
• WARNING! Do not put any other ingredients than dry corn in the aluminium cup of the main body
• WARNING! Danger to life from burning. Do not leave children unattended with the device, as improper
use can cause it to fall over and cause severe burns.
EN 04
on the main body
2
is set at the "O" position.
4
1
is set to the "O" position.
4
back on the popping chamber
1
, then place the top cover
3
to the "I" position.
4
to the "O" position.
4
, popping chamber
and main body
2
off the popping chamber
1
.
2
of the device. It is important that the popcorn ejects down the
3
to the "I" position.
4
. This process will take ± 3 minutes.
2
on the popping chamber.
1
are clean and dry.
3
and fill the measuring cup
2
in the aluminium cup of the main body
2
, before starting with another quantity
2
by placing the
2
.
3
Publicité
Table des Matières
