Technical Details; Technical Specifications; Electrical Specifications - Spectro-UV Spectroline uVision Serie Mode D'emploi

Lampe d'inspection ndt à led uv-a / lumière blanche
Masquer les pouces Voir aussi pour Spectroline uVision Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CHARGING AND USAGE OF THE LI-ION BATTERY
Check if the voltage characteristics of the battery charger match the voltage of the AC
outlet.
The lamp will operate for approximately 8+ hours before turning OFF. The UV-365ZSBLC
is designed to automatically shut off if the unit operates outside of compliance standards.
To turn the unit back ON from a shut off event, turn the lamp OFF and then ON using the
three-position rocker switch. The Battery Indicator light will be Orange when the battery
is charged and the lamp is operating within RRES compliance. When the battery is
nearly depleted, the light will flash between Red and Orange.
Only charge indoors on a dry surface. See warning label on charger for more information.
BATTERY LED INDICATOR STATUS
Orange, Power on, battery good
Blink Orange and Red = Low Battery; time left approx. 10 – 15 mins
Red = Dead Battery, Approx. 5 minutes or less remaining
Shut Down
CARE AND USE OF LITHIUM-ION (Li-ion) BATTERIES
Li-ion battery packs last longer when charged and stored in a temperature range
between 50°F to 86°F (10°C to 30°C) away from heat, sunlight and humidity.
Always charge batteries to full capacity before long-term storage (approximately 30 days)
to prevent aging. After storage they must be charged, which may require conditioning
(two or three charge/discharge cycles) to reach full capacity.
Do not subject these batteries to repeated deep discharges that run the batteries down
completely on a regular basis as this will greatly shorten battery life.
Li-ion batteries generally have no voltage sag until the last 10% of charge.
Li-ion batteries have no toxic lead or mercury, and a life expectancy of 500 charge/
discharge cycles or more, provided the battery is not overcharged or heavily discharged.
Recycle according to local disposal laws.
To Charge the Lamp,
Connect the Battery
Charger to the Unit
4
MEASURING LAMP INTENSITY
To ensure that your uVision™ series lamp is operating at the required UV intensity, it should
be checked periodically. Spectro-UV offers a variety of sensors and meters. The AccuPRO™
XP-2000 combines the functionality of a UV and visible light radiometer/photometer, and is
specially designed to measure UV irradiance with wavelengths of 320–400nm (with peak
at 365nm) and visible light from 460–675nm (with peak at 555nm). Other suitable meters
include the AccuMAX™ XRP-3000 radiometer/photometer kit, using dual-wavelength
UV-A and VIS sensor detectors to accurately measure the irradiance of a light source. The
AccuMAX™ XR-1000 digital readout unit with the XS-365 UV sensor or the DM-365XA digital
readout unit can also be used for UV-A measurement. For product information and technical
assistance, call us at 1-866-230-7305. Consult Safety Data Sheet (SDS) on our website at
www.Spectro-UV.com.

Technical Details

KEY FEATURES OF UV-365Z SERIES
Long-lasting UV-A lenses.
Cool running, fanless design.
Lightweight and rugged construction.
White Light, LED Inspection Light.
IP65 Rated: The uVision™ Series lamps are protected from total dust ingress and from
low pressure jets of water (from all directions). For more details, consult EN 60529
(British BS EN 60529:1992, European IEC 60509:1989).
UV-365ZSBLC: Nominal steady state intensity of 4,500 µW/cm
15 inches (38cm).
Large 6-inch diameter coverage area at 15 inches (38cm) with a minimum UV-A
intensity of 1,200 µW/cm
.
2
Less than 1.0 foot-candle (11 lux) emission.
Certificate of Conformance (ASTM E3022-18) included.
Validation Report (Rolls Royce RRES 90061) included.
UV-365ZHC: Nominal steady state intensity of 8,000 µW/cm
inches (38cm).
Large 7.5-inch diameter coverage area at 15 inches (38cm) with a minimum UV-A
intensity of 1,200 µW/cm
2
.
Less than 1.0 foot-candle (11 lux) emission.
Certificate of Conformance (ASTM E3022-18) included.

TECHNICAL SPECIFICATIONS

uVision™ Series
Height
Length
Width
Weight
Light Source

ELECTRICAL SPECIFICATIONS

Battery Charger:
AC Input: 100-240V/50-60Hz, 0.4A
DC Output: 16.8V/1.8A
2
(+/- 250 µW/cm
(+/- 250 µW/cm
2
UV-A (365nm) and white light
9.5 inches
4.625 inches
3.75 inches
2.65 lb. (1,202 g)
3 UV-A LEDs, 1 white light LED
5
2
) at
) at 15
2

Publicité

Table des Matières
loading

Table des Matières