How To Play; Tips; Troubleshooting - Excalibur electronics Nascar Manuel De L'utilisateur

ENGLISH

How to Play

To begin, insert the
antenna wire through the
hollow tube. Avoid pulling
the wire too tight. The wire
is on the top of your 1:10
Nascar RC. Tie a knot on
®
top to secure.
Turn the switch to the
position for power.
ON
In a clockwise direction,
screw the antenna into the
cavity located at the top of
the transmitter.
Use the control switches
on the transmitter to drive
your 1:10 Nascar RC. It
®
will allow you to drive it
forward, reverse, left and
right. You can also honk its
horn and lift its left and
right doors up.
Use both control switch-
es to turn. If you want to
turn right while driving for-
ward, switch the right
Changes or modifications to this unit not expressly
approved by the party responsible for compliance could
void the user's authority to operate the equipment.
switch right and switch the
left switch up. If you want
to turn left while driving in
reverse, switch the right
switch left and switch the
left switch back.

Tips

If your vehicle does not
•
respond to the transmitter,
move closer to your 1:10
Nascar RC and try again.
®
If your vehicle starts to
•
lose power, it may experi-
ence loss of performance. If
this happens, simply re-
place with new batteries.
If your vehicle moves
•
slowly, try changing the
batteries and check the
wheel mechanisms for lint,
thread, hair or dust.
When the transmitter
•
range decreases, replace the
battery in the controller. If
6
someone uses a CB nearby,
it might interfere with con-
trol of the car. If this hap-
pens, move the car and
transmitter away from the
CB.
Trouble-
shooting
If your 1:10 Nascar RC
®
doesn't move, please check
the following potential
causes:
1. The switch is
turned off. If that is the
POWER
case, turn the switch
on.
POWER
2. Your 1:10 Nascar RC
®
is too far away from the
controller. If that is the case,
bring your 1:10 Nascar RC
®
closer to the controller.
3. The metal tab in the
battery cartridge is flattened
and not touching the batter-
ies installed. If that is the
case, lift up the metal tab so
it touches the tip of the bat-
tery.
ENGLISH
If you lose control of your
1:10 Nascar RC, please
®
check the following poten-
tial cause:
Another radio control
vehicle using the same fre-
quency is operating near
your vehicle. If that is the
case, you should race other
vehicles that use different
frequencies or channels.
If your 1:10 Nascar RC
®
drives slowly, please check
the following potential
causes:
1. There are weak batter-
ies in the transmitter. If that
is the case, replace with
new batteries.
2. There is strong inter-
ference in the surrounding
area. If that is the case, you
should move to a better
location to drive your 1:10
Nascar RC.
®
7