Publicité
Les langues disponibles
Les langues disponibles
7.
Temporarily fasten the sleeper skirt through four existing holes in truck (See Figure 3). Ensure the top of the
skirt is snug up against the truck to minimize the gap.
8.
Remove Sleeper panel and drill hole (marked in step 7) to 9/32" diameter.
Reinstall Sleeper panel and fasten in place with supplied hardware. Use (5) ¼"-20X ¾" hex head bolts with (2)
9.
flat washers a (1) locknut at each fastener.
Align sleeper panel to Cab panel, and secure together with supplied ¼"-20X ¾" hex head bolts with (2) flat
10.
washers and a (1) locknut on each fastener.
Position Extender panels in place and mark holes to be drilled in bottom of extender.
11.
12.
Remove Extender panel and drill holes (marked in step 11) to 7/32" diameter.
13.
Reinstall Extender panels and secure with 10-32X3/4" bolts.
Repeat all steps on the other side of vehicle.
14.
15.
Peel plastic and clean with glass cleaner as required.
Page 2 of 6
FIG. 2 – DRIVER CAB PANEL, SHOWN FROM BACK
FIG. 3 – DRIVER SLEEPER PANEL, SHOWN FROM BACK
00813030
05/2018
Publicité
