Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTRUCTION SHEET
#303780
Retain this manual
for future reference.
INSPECT CONTENTS IMMEDIATELY AND FILE CLAIM WITH DELIVERING CARRIER
FOR ANY DAMAGE
RESPONSIBLE FOR DAMAGE TO YOUR UNIT IF RETURNED IMPROPERLY PACKED.
(model shown: HT3CB-120)
• This hot food table is designed to be operated dry. If wet operation is required, spillage pan (#302027) must be used.
• The unit is for holding hot food for short periods of time. When not serving, cover must be kept on food to maintain desired temperature.
• During initial start up, a little smoke or odor may be detected. This will occur when the coating on the heating element burns off.
This should stop approximately a half hour after start up.
• This hot food table is equipped with a variable control for different selections.
Eagle Foodservice Equipment, Eagle MHC, and SpecFAB
Electric Dry Hot Food Table
DHT Series and HT_OB/CB Series
OPERATING MANUAL AND INSTRUCTIONS
. SAVE YOUR BOX AND ALL PACKING MATERIALS.
Contact a factory representative or Eagle's authorized service center in your area.
(model shown: DHT3-120)
HT_CB unit
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A.
• Phone: 302/653-3000 • 800/441-8440 • Fax: 302/653-2065
• www.eaglegrp.com • www.eaglegrpnews.com • www.eaglemhc.com
CAUTION
DHT unit
(model shown: HT3OB-120)
ELECTRIC
are divisions of Eagle Group. ©2022 by the Eagle Group
®
YOU ARE
HT_OB unit
EG9811
Revised 12/22
Publicité
Manuels Connexes pour Eagle Group DHT Serie
Sommaire des Matières pour Eagle Group DHT Serie
- Page 1 • 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • Phone: 302/653-3000 • 800/441-8440 • Fax: 302/653-2065 • www.eaglegrp.com • www.eaglegrpnews.com • www.eaglemhc.com Eagle Foodservice Equipment, Eagle MHC, and SpecFAB are divisions of Eagle Group. ©2022 by the Eagle Group ®...
- Page 2 ASSEMBLY INSTRUCTIONS Standard Adjustable Undershelf (for DHT Series only) Optional Bolted Undershelf (for DHT Series only) NOTE: Legs and undershelf must be NOTE: Legs and undershelf must be assembled BEFORE securing legs to table. assembled BEFORE securing legs to table. Figure 1 Figure 1 1.
-
Page 3: Parts List
ASSEMBLY INSTRUCTIONS Push Handle (for all units with casters) 1. Determine which end the handle is to be attached. 2. Remove the existing screws from the end panel. 3. On the handle, remove the self-adhesive strip of black vinyl held in place for shipping by a static charge. Remove strip to expose countersunk screw holes (see Figure 1). - Page 4 Limited Warranty for Eagle Products Metal Masters Foodservice Equipment Co Inc. d/b/a Eagle Group or Eagle Foodservice Equipment (“Eagle”) hereby warrants to you, the original purchaser and end-user (“you” or “your”), that the products manufactured by Eagle that you purchased which accompany this Limited Warranty (“products”) shall be free from defects in materials and workmanship under normal use consistent with the accompanying documentation for a...
- Page 5 Desserte chauffante électrique PIÈCE #303780 Série DHT et série HT_OB/CB Conservez ce manuel pour MANUEL D’UTILISATION ET INSTRUCTIONS référence future. ATTENTION INSPECTEZ LE CONTENU IMMÉDIATEMENT ET DÉPOSEZ UNE PLAINTE AUPRÈS DU . CONSERVEZ LA CAISSE ET TOUS TRANSPORTEUR EN CAS DE DOMMAGE LES MATÉRIAUX D’EMBALLAGE.
- Page 6 INSTRUCTIONS DE MONTAGE Standard d'ajustement de la tablette inférieure Tablette inférieure boulonnée en option (pour série DHT uniquement) (pour série DHT uniquement) REMARQUE : Les montants et la tablette REMARQUE : Les montants et la tablette inférieure doivent être assemblés AVANT de inférieure doivent être assemblés AVANT de fixer les montants à...
-
Page 7: Liste De Pièces
INSTRUCTIONS DE MONTAGE Poussez le traitement (pour les unités portatives) 1. Déterminez quelle extrémité le traitement doit être joint. 2. Retirez les vis existantes du panneau d'extrémité. 3. Sur le traitement, retirez la bande auto-adhésive du vinyle noir tenue en place pour expédier par une charge statique. Retirez la bande sur les trous de vis fraisés par exposition (voir Figure 4. -
Page 8: Garantie
Garantie limitée pour les produits Eagle Metal Masters Foodservice Equipment Co Inc. d/b/a Eagle Group ou Eagle Foodservice Equipment («Eagle») vous garantit par la présente, l'acheteur initial et l'utilisateur final («vous» ou «votre»), que les produits fabriqués par Eagle que vous avez acheté et qui accompagnent cette garantie limitée («produits») seront exempts de défauts de matériaux et de fabrication dans des conditions normales d'utilisation conformes à...