Brandson Equipment 303846 Mode D'emploi page 29

When the set temperature is higher than the current air temperature, the appli-
ance switches on again and heats until the desired room temperature is reached.
Timer function
Press the " " button to switch on the timer. Every time you press the timer but-
ton, the value increments by one hour, up to a maximum of 12 hours. Press the
timer button again to reset the timer. The time duration set is shown in the display.
As soon as the timer is set, the countdown function starts counting down and
switches off the appliance at the end of the timer count.
7. Overheating
Overheating generally occurs only if one of the openings of the fan heater is
blocked. This appliance comes with a self-resetting thermal fuse. The heater
switches off automatically once the overheating temperature is reached. The fan
heater can be operated again once the fuse is reset.
8. Cleaning and Care
Completely switch off the appliance and disconnect it from the power supply be-
fore you start cleaning it. Clean the housing with a slightly damp cloth, a vacuum
cleaner or a dusting brush. Never use flammable, aggressive or scouring cleaning
agents such as benzene or spirit to clean. Clean the air inlet and outlet regularly
using a vacuum cleaner. If the appliance is not going to be used for a long time,
then it must be protected against excessive dust and dirt.
29
English