Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 3.04
PRODUCT DIAGRAM
OPENING INSTRUCTIONS
1.
Carefully remove the heater from carton and the bag. Make certain the unit is in the OFF
position before plugging the heater into the power outlet.
2.
Before using the heater, make sure that it is on a flat and stable surface. Damage may occur if
it is placed in an incline or decline.
3.
Turn off all the controls of the heater, and then plug the heater power cord directly into a
standard grounded AC outlet. Be sure plug fits tightly into outlet.
4.
To completely shut the heater off, turn all the controls to OFF, and remove plug from the
socket-outlet.
POWER SETTING
1.
Main Power Switch: Use this switch to turn the product on and off.
2.
Heat Setting Switch: Use this switch to set the heat setting:
"0" ("0" - off, no heat)
"1" – Low Heat Setting (600 Watts)
"2" – High Heat Setting (1200 Watts)
3.
Turn the Thermostat Control Knob clockwise to its maximum range. The Power Indicator will
illuminate, indicating the Heater is on.
4.
Allow the product to operate until the ambient room temperature reaches the desired
comfort level.
5.
Slowly turn the Thermostat Control Knob counter-clockwise until the product turns off. The
product will cycle on and off to maintain the setting.
6.
To adjust the thermostat, turn the Thermostat Control Knob towards maximum to increase
the set ambient temperature and towards minimum to decrease it.
4
Quartz Tower Heater
Fig. 1
Fig. 1
For technical questions call: 1-800-665-8685
8548745
Publicité
Table des Matières
