Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
V 4.04
ASSEMBLY
Attach the handle (B) to the top of the heater (A) with the two screws (C) provided using a Phillips
screwdriver (not included).
OPERATION
1.
Place the product upright on a flat, level, stable, heat-resistant
surface. Plug the power cord into a standard 120-volt electrical
outlet. The power indicator will illuminate, indicating the heater (A)
is on.
2.
Main Control Knob (Figure 1): Use this button to set the
heat setting: "1 (1,300 W)" – Low heat setting "2 (1,500 W)" – High
heat setting.
3.
Turn the thermostat control knob clockwise to adjust the
room temperature
4.
Allow the product to operate until the room temperature reaches the
desired comfort level.
5.
Slowly turn the thermostat control knob counter-clockwise until
heater turns off. The heater will cycle on and off to maintain
the setting.
6.
To adjust the thermostat, turn the thermostat control knob toward high to increase the set
ambient temperature and toward off to decrease it.
7.
When the unit has been overheating, the thermal cut-out trips, the unit needs to be reset.
Before resetting the unit, turn the control knob to OFF and unplug the heater. Check if
the air vents are blocked or if there is another problem. Once the problem is corrected,
wait 10 minutes for the unit to cool down. After 10 minutes, plug the unit in again and
operate normally.
8.
Turn off the product by rotating the thermostat knob to the "OFF" position, and then unplug
the product from the electrical outlet.
6
Milkhouse Heater
For technical questions call: 1-800-665-8685
8549743
Fig.1
Fig.2
Publicité
Table des Matières
